Project Door

I have been busy for the past month on a secret project of mine.

it’s the DOOR.

I got to fit a door!!!!

it is not as easy as going to the hardware store and buy a door.  Because it isn’t a standard door, i’ve need to order a custom made door for it.

When the door arrives, it is a panel of wood, and thats it.  there’s no pre-drill hole for door knobs or anything

just a plain piece of big wood.

then

i went out and bought 3 items

1.  the screws for the hinges

2.  door lock kit

and

3.  door installation kit (with saw drill for doors and locks)

first i need to measure where the existing locks are, and mark them. 

then i will mark where the door knobs will go.

 

take out the saw drill bit and fit it to the

door and start drilling

 

 

A HOLE FOR THE DOOR KNOB…

Next…

drill holes for the lockLock hole Drilled!!!!

Measure where the existing hinges will go and got to cut 1mm set back for the hinges.

bear in mind, i couldn’t find a chisel at the time, so ive used a knife to try to cut it.

  

and ok i failed.

so i went out and bought a set of chisel.

TADA

Chisel

 

 

 

 

 

chisel away some wood for set back for the hinges

of course there’s two hinges!!

so need to make 2 setback for 2 hinges

once done…

screw the door or attach the door to the frame.

 

not 100% done….

still need to paint them

 

Let me present

AN

UNCLOSEABLE

DOOR!!!!!!!!

the door is freaking wide ok….!

i’ve thought i made 2mm allowance for opening.

obviously its not enough lar….

gotta make at least 4-5mm allowance total for both side.

NOW wats left is to Chisel or Plain all those access wood away…

that’s another 2 wkend’s project…eugh!!!!!!!!!!!!!!

@!#*&&#@*(&#!@*(&@(